MODEL parameter

From m204wiki
Revision as of 21:07, 23 April 2015 by JAL (talk | contribs) (misc formatting)
Jump to navigation Jump to search

Terminal model

Summary

Default value
2
Parameter type
User
Where set
On user's parameter line
Related products
All
Introduced
Model 204 V6.1 or earlier

Description

The alternate screen sizes corresponding to the different models within the IBM 3270 family of terminals

These sizes are available at command level and during output from SOUL statements. For all values except MODEL=5, they also are available for SOUL screens and menus and the Full Screen Editor.

For MODEL=5, SOUL screens and menus use the full height (26 available lines), but only up to 80 columns of width. In addition, if MODEL=5, the Full Screen Editor uses the size corresponding to MODEL=2.

For terminals communicating through SNA Communications Server, CICS, IUCV, or TSO, Model 204 automatically sets MODEL to the appropriate value when the session begins, provided that the size of the output page buffer ([[LOUTPB parameter|LOUTPB) is large enough to hold the new screen size.

If you set the FSTRMOPT parameter to 2, the MODEL parameter is not reset dynamically. When the value of MODEL is reset from 2 (the default), the values of the OUTLPP, OUTMRL, and INMRL parameters are adjusted accordingly, as shown in the following example.

The screen-size parameter settings for IBM 3270 terminals are shown in the table below.

Screen-size parameter settings
MODELMINIMUM LOUTPB OUTLPP OUTMRLTERMINAL INMRL TYPE
1117011 80 78IBM 327x Model 1
2213023 80 78IBM 327x Model 2
3277031 80 78IBM 327x Model 3
4365042 80 78IBM 327x Model 4
5377426132130IBM 327x Model 5
6customcustomcustomcustomCustom tn3270 setting — see Terminal MODEL 6 support

Note: The 3278 Model 2A and the 3279 Model 2C system consoles are not supported in full screen mode.

The values of OUTCCC and INCCC can also be affected. If they are greater than the new OUTMRL and INMRL values, they are set equal to the new values. If they were originally equal to OUTMRL and INMRL, they are made equal again. For example, if the original value of OUTCCC is 80, resetting MODEL from 2 to 5 also resets OUTCCC to 132.

When MODEL is reset, any existing backpages can no longer be displayed.