DmeWiccan: Automatically generated page update

2018-02-14T12:44:40Z

Automatically generated page update

New page

{{Template:M204.0165 skeleton}}

While scanning the CCARF data set, Model 204 has detected the end of an update unit for which no corresponding start of update unit was found. Possible explanations for this error are: 
<ul>
<li>A utility program was used to copy the original journal to data set being used as CCARF, and a portion of the original data set was not copied. </li>
<li>A copy was not done. </li>
</ul>

System manager response: If the original journal was a multi-volume data set and was copied to another data set for input to this run, verify that all volumes were in fact copied, and rerun the job. If CCARF was the original data set, contact [[Contacting Rocket Software Technical Support|Technical Support]]. Have the following documentation available: 
<ul>
<li>Audit trail of the original run </li>
<li>Snap </li>
<li>UTILJ of the CCARF data set or a copy of this data set on tape </li>
<li>UTILC of the restart data set or a copy of this data set on tape </li>
</ul>
{{Template:M204.0165 footer}}

M204.0165 - Revision history

DmeWiccan: Automatically generated page update