JOBSTEP parameter: Difference between revisions
(Automatically generated page update) |
|||
| Line 30: | Line 30: | ||
</p> | </p> | ||
The JOBSTEP parameter also appears in the informational message M204.0061 during system initialization. | The JOBSTEP parameter also appears in the informational message M204.0061 during system initialization. | ||
[[Category:System | [[Category:System parameters]] | ||
[[Category:Parameters]] | [[Category:Parameters]] | ||
Revision as of 01:51, 23 April 2013
Summary
- Default value
- None
- Parameter type
- System
- Where set
- View-only
- Related products
- All
- Introduced
- Model 204 V7.4
Description
The JOBSTEP parameter should be blank unless you are executing a JCL PROC.
When Model 204 runs as part of a JCL PROC, and you execute the same JCL PROC repeatedly in a given JCL stream, you can identify each JCL PROC by its JOBSTEP value.
JOBSTEP: the JOBSTEP name on the EXEC JCL card that runs the JCL PROC.
STEPNM (if JOBSTEP is not blank): the name on the EXEC JCL card that specifies the module name in the PGM=JCL parameter.
Example:
//PROCNM PROC ZGM=ONLINE //ONLINE EXEC PGM=&ZGM, <<<<< STEPNM parameter value .... // PEND //JOBSTNM EXEC PROCNM ZGM=ONLINE <<<< JOBSTEP parameter value .... V JOBSTEP JOBSTEP JOBSTNM JOB STEP NAME V STEPNM STEPNM ONLINE STEP NAME
The JOBSTEP parameter also appears in the informational message M204.0061 during system initialization.