COMEND parameter: Difference between revisions
Jump to navigation
Jump to search
| Line 16: | Line 16: | ||
==Description== | ==Description== | ||
<p>COMEND specifies two characters that signify the end of a block of comments.</p> | <p>COMEND specifies two characters that signify the end of a block of comments.</p> | ||
<p>If you want to change the COMEND parameter from the default, ?/, to */, issue the following command: </p> | <p>If you want to change the COMEND parameter from the default, ?/, for example to */, then issue the following command: </p> | ||
<p class="code">RESET COMEND C'*/' | <p class="code">RESET COMEND C'*/' | ||
</p> | </p> | ||
Revision as of 09:05, 14 October 2014
End of comment block
Summary
- Default value
- ?/
- Parameter type
- User
- Where set
- On user's parameter line
- Related products
- All
- Introduced
- Model 204 V4.2
Description
COMEND specifies two characters that signify the end of a block of comments.
If you want to change the COMEND parameter from the default, ?/, for example to */, then issue the following command:
RESET COMEND C'*/'
Rocket Software recommends using the default value. If you reset the parameter to another value, avoid reserved characters and test your new value thoroughly. For details about using COMEND and COMSTART, resetting the values to /* and */, and handling dummy strings, see the Rocket Model 204 User Language Manual, Part I-II in the section about commenting your code.