AUDTERM (JANUS DEFINE parameter)

<section begin="desc" /><section end="desc" />

AUDTERM is a parameter on JANUS DEFINE, which defines and sets characteristics of a Janus port. See the List of JANUS DEFINE parameters.

This parameter is used to control whether the server thread sends "non-compiler terminal output" to the audit trail. Compiler terminal output is always sent to the audit trail. Any terminal output sent to the audit trail is sent as RK lines.

AUDTERM specifies that terminal output is sent to the audit trail; NOAUDTERM (:hdref refid=noaudt.), which is the default port setting, specifies that (non-compiler) terminal output is not sent to the audit trail.

Note that some "print output" can be "captured" on a Sirius $list, a Janus Socket, or a USE output stream, and thus it would not be sent as terminal output -- to the audit trail or anywhere else. For further description of terminal output, see :hdref refid=outpcli.. see :hdref refid=prtcap.. see the Janus Web Server Reference Manual or Janus Sockets Reference Manual.

On a WEB port:

• Even with AUDTERM set on a WEB port, terminal output is not sent to the audit trail if $Web_On is explicitly or implicitly set.
• The setting of AUDTERM (or NOAUDTERM) applies to all URLs on a WEB port unless explicitly overridden by a NOAUDTERM (or AUDTERM) parameter on a JANUS WEB ON rule.

On a SRVSOCK port:

• The setting of AUDTERM (or NOAUDTERM) for a socket can be changed using the $SOCK_SET function or the Socket object method Set.

Starting with Version 6.0, this parameter applies to all Janus "server" port types, and the default setting is NOAUDTERM. Prior to this, the parameter only applied to WEB ports, and the default setting was AUDTERM.

This introduces a small incompatibility. Starting with Version 6.0, compared to earlier versions, any WEB port connection without an explicit AUDTERM or NOAUDTERM will probably generate fewer audit trail lines, as will any SDS or OPENSERV port. This should be a benefit, since most of this output is either uninteresting or already logged to the audit trail as ER, AD or MS lines. Logging these messages as RK lines as well is just a waste of journal space and I/O and makes application diagnosis and debugging from the audit trail more difficult because of the extra noise data. For WEB, OPENSERV, or SRVSOCK applications that wish to explicitly audit information, the User Language AUDIT statement should be used, not the PRINT statement.

Valid for WEBSERV, SDS, OPENSERV, or SRVSOCK port types.

Not valid for CLSOCK port types.

References

See: List of Janus commands | List of JANUS DEFINE parameters.