From m204wiki
Revision as of 21:38, 16 March 2018 by JAL (talk | contribs) (add <var>s)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

M204.2324  LANGFILE index​=​token not found in NLANG for file fileName

An OPEN FILE or RESTORE command has detected an inconsistency between the LANGFILE parameter stored on the file (or backup) and the list of languages available in the NLANG module. The index is negative or too big. This problem can be caused by one of these:

  • File corruption
  • A mismatch between the NLANG module used to create the file and the NLANG module used to open or restore the file.

System manager response: Determine which of the two causes is responsible for the problem. If the language index printed in the message is negative or very large, it is likely that the file's FPL page has been corrupted. If you are not certain of the cause of the problem, Technical Support may be able to assist you if you provide the following:

  • The SNAP that was produced with the message.
  • A dump of the NLANG$ CSECT from the Model 204 module.

If the cause of the problem is an NLANG file mismatch, you can still open the file with the Model 204 module that was used to create the file. Otherwise, contact Technical Support.

Message attributes:

RETCODEO=0Sets online return code
RETCODEB=4Sets batch (single user) return code
CLASS=EError class; the message can be suppressed with the X'04' bit setting of the MSGCTL parameter
AUDITERWrites the message with line type ER to the audit trail
COUNTIncrements the error count (ERCNT) parameter
SNAPGenerates a CCASNAP for the run

Back to list of messages