MSIR.0916 Could not connect to (ipaddr) port (portnum): Difference between revisions

From m204wiki
Jump to navigation Jump to search
(Created page with "This message indicates that a SIRIUS DEBUG or SIRIUSDEBUG command failed because it was unable to connect to the indicated debugging client. <li>th The most common causes for thi...")
 
m (1 revision)
(No difference)

Revision as of 16:58, 9 November 2010

This message indicates that a SIRIUS DEBUG or SIRIUSDEBUG command failed because it was unable to connect to the indicated debugging client.

  • th The most common causes for this problem are:
    • The target client's IP address or host name was incorrect. Correct the address of host name.
    • The target client's port number was incorrect. Correct the port number.
    • The debugging client was not started on the target workstation. Start the debugger client on the workstation and reissue the command. Note that the client must be installed on the target workstation. For more information about the Sirius Debugger client see the "Janus/Sirius Debugger User's Guide".
    This message should be preceded by other messages giving more details about the nature of the communications error. If the problem is still not obvious, contact Sirius Software technical support for assistance.