Model 204 installation on IBM z/VSE: Difference between revisions

From m204wiki
Jump to navigation Jump to search
No edit summary
Line 1: Line 1:
<span style="color:#BA0000"><b>Note:</b> This page is currently under construction.</span>
This page describes the installation steps for Model 204 version 7.5 on the IBM z/VM CMS operating system.
==Allocating data sets==
==Allocating data sets==
There are three data sets used during Model 204 installation:
There are three data sets used during Model 204 installation:
Line 19: Line 23:
<li>Submit the <code></code> job to allocate the data set.
<li>Submit the <code></code> job to allocate the data set.
</ol>
</ol>
[[Category:Installation]]

Revision as of 19:51, 21 November 2014

Note: This page is currently under construction.

This page describes the installation steps for Model 204 version 7.5 on the IBM z/VM CMS operating system.

Allocating data sets

There are three data sets used during Model 204 installation:

  • data set for the Model 204 load modules
  • data set for the local source library
  • data set for the local object library

The data set for the load modules will contain, after linking, the modules for the Model 204 product, including: ONLINE, IFAM1, and IFAM4. The local source library is used to store the customized source for modules such as FUNU, MSGU, and ACF2PARM/RACFPARM/TOPSPARM. When the source is assembled, it is stored in the local object library.

You will need to edit and submit the M204CATP job stream to allocate data sets for the installation.

Edit the job streams as follows:

  1. Replace the first line with a JOB card.
  2. Edit the lines, near the top of the job stream, marked with numbers followed by <<. The numbers correspond to numbered steps in the comments following these lines.
  3. Submit the job to allocate the data set.