Table B (File architecture)

This topic covers the internal architecture of a Model 204 Table B page.

For a discussion of the ways a File Manager may organize these pages in a file, please refer to File Design (File Management).

At a minimum, Table B contains all of the base records in a Model 204 file. If Table X is not enabled it also contains all extension records. If Table E is not enabled, then any data whose contents is greater than 255 bytes must be held as a series of repeating fields.

The structure of a Table B page

Not shown is a 4 byte 'Reuse Queue Page Number' for Unordered Files. If it is present, it is in the lower left hand corner ('before' (working backwards) the first record on the page).

Each of the items in the chart are described, below:

Pointers

Free Space Pointer

The free space pointer contains the location of the first byte of free space on the page (as shown in the diagram, where the last record on the page ends). On pages with no records yet stored, it points to the last byte on the page (either the very end, of just before the Reuse Queue Page Number described above).

Record Pointer Array

There are up to BRECPPG record pointers. These are not physically put onto the page until the record is being added to the file.

Up to because, (except as noted below) it is possible that, as large records are stored, there will not be room for the full number of BRECPPG on the page, and so they would not be stored.

For Enhanced Data Handling FILEORG x'100' files, with RECRDOPT set to x'01', you will always have space for the full number of BRECPPG record pointers, as their length is included in the calculation of the BRLIMSZ parameter.

Space Management Across Pages

Extension Records

Refer to Records and Adding Records for a full discussion of record architecture.

Table B Segments

Definition

As discussed below, bit maps are used

Use in Indexing

===

The Reuse Queue

The following Parameters relate to the Use of Table B

This table excludes the parameters used for Hash Key and Sorted Files. Please see those topics for a full discussion of their special parameters (and distinction in meanings for some of these).

Also not shown are the parameters which control the automatic increase in table size, which see.

BHIGHPG parameter	Table B highest active page. Normally the high water mark of pages used (except for Hash Key and Sorted files). Viewable only.
BQLEN parameter	The number of pages in the reuse queue. Viewable only.
BRECPPG parameter	The maximum number of record slots on a Table B page.
BRESERVE parameter	Table B Reserved space.
BREUSE parameter	The minimum amount of space necessary to add a page to the reuse queue.
BREUSED parameter	The numberof record slots reused.
BRLIMSZ parameter	Base record size maximum. Viewable only.
BSIZE parameter	The number of pages in Table B.
RECRDOPT parameter	Record storage options.