$Web_Put_Text
Add text string to response buffer
$Web_Put_Text sends a text string to the client buffer.
$Web_Put_Text is a callable $function, and it takes a single required string argument and returns a status code.
Syntax
%rc = $Web_Put_Text( string )
Syntax terms
| %rc | A numeric status code. |
|---|---|
| string | A text string that is translated from EBCDIC to ASCII and added to the client buffer. Under Sirius Mods Version 6.7 and later, $Web_Put_Text is longstring capable: it can send a longstring with a length greater than 255 bytes. |
Status codes
| Code | Meaning |
|---|---|
| 0 | String sent to the client buffer. |
| -1 | Invalid call, not a Web thread |
| -4 | Missing argument |
Usage notes
The primary uses for $Web_Put_Text are:
- To send text to a browser when $Web_Off is set: it might be easier to do a $Web_Put_Text than a $Web_On, PRINT, $Web_Off sequence.
- To have text that is to be sent to a browser embedded in code that is also used in non-browser (for example, 3270 or BATCH2) mode. $Web_Put_Text acts as a no-op when executed on a non-web thread so can be used instead of an IF test (to determine if running on a web thread) followed by a PRINT statement.
Examples
The following example shows an entire HTML document being sent to the client, a line at a time. Note that you could also direct HTML to the client by sending a procedure that contains HTML (using $Web_Proc_Send) or simply with PRINT statements (unless $Web_Off has been issued).
%X = $Web_Type('text/HTML') %X = $Web_Put_Text( '<HTML>' ) %X = $Web_Put_Text( '
' ) %X = $Web_Put_Text( 'Hello World' ) %X = $Web_Put_Text( '</HTML>' ) STOP
See also
- $Web_Proc_Send can be used to send the contents of a Model 204 procedure, either as binary (that is, without translation) or translating from EBCDIC to ASCII.
- $Web_Put_Binary adds a string to the web output buffer without translation.