Default settings of buttons and hot keys
Unless you have provided a user interface reconfiguration file, the Debugger Client starts with the default presentation of GUI buttons and hot keys summarized in this section.
Buttons
The ten buttons above the Client's main window tabs are initially set to perform the commands that are shown in the table below (and described further in The Client command reference). The buttons are named by their left-to-right position. The button labels shown in the Client are close approximations if not the same as the name of the command they execute, and the labels are configurable with the labelButton command. Five additional buttons are available for mapping but have no command associated with them by default, and they do not appear unless they are explicitly mapped:
| Button | Default command setting |
|---|---|
| button0 | top |
| button1 | bottom |
| button2 | clearAudit |
| button3 | run |
| ALT-button3 | runWithoutDaemons |
| button4 | step |
| button5 | stepOver |
| ALT-button5 | stepOut |
| button6 | trace |
| button7 | cancel |
| button8 | clearBreaks |
| button9 | clearWatch |
| button10 | (none) |
| button11 | (none) |
| button12 | (none) |
| button13 | (none) |
| button14 | (none) |
Hot keys
The Client's default set of hot keys and the commands that they perform are shown below.
| Hot key | Default command setting |
|---|---|
| ALT-B | breaksAt |
| CTRL-B | breaks |
| CTRL-C | copy |
| CTRL-F | focusToSearchBox |
| CTRL-P | preferences |
| CTRL-T | trace |
| CTRL-U | searchFromBottom |
| CTRL-X | cancel |
| F4 | step |
| F5 | run |
| ALT-F5 | runWithoutDaemons |
| F9 | searchDown |
| ALT-F9 | searchUp |
| F10 | stepOver; also, previousCompileError |
| ALT-F10 | stepOut |
| F11 | step; also nextCompileError |
Note: By default, the Enter key repeats the command performed by the currently active button which is highlighted.