JANUS STATCA or STATUSCA

<section begin="desc" />Display certificate status<section end="desc" />

This command displays the status of "trusted" certifying authority certificates that have been added to a port with the JANUS ADDCA command (JANUS ADDCA).

Certifying authority is often abbreviated CA. STATCA is a valid synonym for STATUSCA.

Syntax

<section begin="syntax" /> JANUS STATUSCA [portname] [filename] [procname] <section end="syntax" />

JANUS STATUSCA command syntax

Each parameter is positional, can be specified with pattern wildcards, and can be replaced with an asterisk (*), which returns all values for that category. You may omit a parameter (which is equivalent to specifying an asterisk value for it) if the parameters to its right are omitted.

portname	The defined JANUS port for which the certificate status is to be displayed.
filename	The name of the file(s) for which the certificate status is to be displayed.
procname	The name of the procedure for which certificate status is to be displayed. If not specified, status is displayed for all certificates for the indicated port(s) and file(s).

JANUS STATUSCA provides the following information:

Portname	Name defined for the TCP/IP port.
Filename	File from which the certificate was loaded.
Procname	Procedure from which the certificate was loaded.
Internal-name	The "common name" of the certifying authority as specified in the certificate.
NumSigned	The number of certificates received that were signed by the certifying authority associated with the indicated certificate.

The following example shows the format of STATUSCA output, in this case for a single Sirius-certified certificate:

JANUS STATCA SSLCLI Portname Filename Procname Internal-name NumSigned SSLCLI GLWPROC GTEST.CERT www.sirius-software.com 1

The JANUS STATUSCA command is only available in Sirius Mods version 6.0 and later.

References

List of Janus commands