Category:User parameters
The User parameters are Model 204 parameters that
- can be set using the Model 204 RESET command by any logged-in user
- affect only the thread on which they are issued
At logout, user parameters are set back to the values they had when the thread was defined, that is, during Online initialization.
PDF of category pages
You can use this link to create a PDF file that contains all the pages in this category. If this category contains a "Subcategories" section, the PDF will also contain a linked list of the pages that belong to each subcategory listed in the "Subcategories" section.
Note: The resulting PDF is not optimized for online use. All blue links except for those in the table of contents (TOC) take you outside of the PDF (typically to http://m204wiki.rocketsoftware.com), so you must rely on the PDF bookmarks and TOC for online navigation. Hovering your mouse over a link will reveal its destination.
Pages in category "User parameters"
The following 121 pages are in this category, out of 121 total.
C
- CASE parameter
- CAUDIT parameter
- CECHO parameter
- CEECHO parameter
- CENTSPLT parameter
- CHKPRIV parameter
- COMEND parameter
- COMPERR parameter
- COMSTART parameter
- CP3270 parameter
- CS3270 parameter
- CSECHO parameter
- CURALVL parameter
- CURCLASS parameter
- CURFILE parameter
- CURPRIV parameter
- CURREC parameter
- CURRLVL parameter
- CURSLVL parameter
- CURULVL parameter